Installing the lock collar, Installing the pulley – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 User Manual
Page 17
Advertising
![background image](/manuals/277884/17/background.png)
4. Assembly
PNEG-1445 6", 8", 10" and 12" Custom Augers
17
Installing the Lock Collar
1. Slide the lock collar over the drive shaft, positioning it against the bearing. Do not tighten the lock
collar at this time as it will be tightened later in the assembly.
Figure 4H
Installing the Pulley
1. Place and position the key into the keyway located on the drive shaft.
2. Place the pulley onto the drive shaft with the set screw side of the pulley facing away from the
bearing plate. Position the pulley so that it is as close to the lock collar as possible, but not
touching it.
3. Once the pulley is appropriately positioned, tighten the set screw with a hex head wrench to secure
it to the drive shaft.
Figure 4I
Advertising