Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 - Manual (Page 28)

28 PNEG-1445 6", 8", 10" and 12" Custom Augers
4. Assembly
Installing Intake Shaft (Continued)
2. Next bolt the bearing with flangette to the studs on the hopper using the required lock washer and
nut. (See Chart below and Figure 4AA.)
Figure 4AA
Attach Hopper
1. Slide the hopper onto the tube and align the end of the flight approximately 1/2" from the surface
of the bearing. With the proper distance set, install the proper bolt, lock washer and nut, and secure
the hopper to the tube.
(See Chart below and Figure 4AB.)
Figure 4AB
Hopper Bearing Nut
6" 5/16"-18 Hex Nut
8" 3/8"-16 Hex Nut
10" 1/2"-13 Hex Nut
Hopper Connecting Band Bolt
6" and 8" 5/16"-18 x 1" Hex Bolt
10" 5/16"-18 x 1-1/2" Hex Bolt