Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 - Manual (Page 21)

4. Assembly
PNEG-1445 6", 8", 10" and 12" Custom Augers 21
Standard Assembly without Bearings (Continued)
3. Slide the extension tube over the extension flight, making sure the tube is pressed securely against
the main auger tube. (See Figure 4N.)
Figure 4N
4. Slide the extension connecting band over the two (2) sections of tube, making sure the connecting
band is centered over the mated surfaces of the tubes. Tighten the connecting band down using
the correct hex bolts and nylock nuts.
(See Chart below and Figure 4O.)
Figure 4O
Connecting Band Bolts
6" and 8" 5/16"-18 x 1" Hex Bolt
10" and 12" 3/8"-16 x 1" Hex Bolt
( See Chart above for bolt sizes.)