Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 - Manual (Page 20)

20 PNEG-1445 6", 8", 10" and 12" Custom Augers
4. Assembly
Assembling the Flight Extension for all 6", 8", 10" and 12"
Custom Augers
Standard Assembly without Bearings
NOTE: If the auger does not include an extension skip ahead to Step 5 on Page 22 .
1. Begin by sliding the extension connecting band onto the main auger tube. (See Figure 4L.)
2. Slide the flight connecting shaft into the main section of flight and bolt together with grade 8 hex bolt
and stover nut. Next slide extension flight onto connecting shaft and bolt together using proper
grade 8 bolts and stover nuts.
(See Chart below and Figure 4M.)
Figure 4L
Figure 4M
Flight Hardware
6" 3/8"-16 x 2" Grade 8 Hex Bolts
8" 7/16"-14 x 3" Grade 8 Hex Bolts
10" 1/2"-13 x 3-1/2" Grade 8 Hex Bolts
12" 5/8"-11 x 4" Grade 8 Hex Bolts
( See Chart above for bolt sizes.)