Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 - Manual (Page 15)

4. Assembly
PNEG-1445 6", 8", 10" and 12" Custom Augers 15
Installing the Motor Mount Adjuster
1. Place motor mount adjuster between the back plate and head plate on the discharge tube.
2. Insert pivot rod through the tube plates and motor mount adjuster. Secure in place with two (2)
3/16" x 2" cotter pins. (See Figure 4D.)
Figure 4D
Installing the Motor Mount Plate
1. Secure one (1) of the motor mount adjustment nuts and one (1) the motor mount adjustment
washers approximately 3/4 of the way down the motor mount adjuster’s threaded shaft.
2. Once the nut and washer is secure, slip the motor mount plate over the adjuster and align the pivot
holes with the pivot tube. (See Figure 4E.)
3. Slide the motor mount pivot rod through the pivot tube on the discharge tube.
Figure 4E