Moog Music Minimoog Voyager XL - Manual (Page 18)

Page 20
Voyager XL User’s Manual - The Components
Page 21
Voyager XL User’s Manual - The Components
Related Oscillator Controls:
Two other panel controls interact with the Voyager XL oscillators: Fine Tune and Glide. These controls are
located to the lower left of the Modulation Busses section
Fine Tune:
The FINE TUNE control is used to tune the oscillators ± 2 semitones for matching an
external reference pitch.
Glide Rate:
Glide enables a glissando effect between notes. The GLIDE RATE control adjusts the
rate of the glissando. The glide rate can vary from a very fast to a very slow glide. It can
be switched on or off using the GLIDE switch in the Voyager XL keyboard left-hand
controller section, or in the PANEL mode menu of the RME. You can also turn glide on
or off by sending a MIDI CC 65 message (0-63 = off, 64-127 = on).
Oscillator CV Inputs on the Patch Panel:
PITCH -
The PITCH jack allows you to connect an external CV or Expression Pedal to control the Voyager XL’ s
pitch. All three oscillators are effected by this connection. The effective input range is -5 to +5 V, where a
positive CV will add to the Oscillator FREQUENCY control knob settings, and a negative CV will subtract
from the settings. If an Expression Pedal is used, the pitch can only be made to increase, since the pedal
connection supplies only a positive voltage.
WAVE -
The WAVE jack allows you to connect an external CV or Expression Pedal to control the oscillator wave-
forms. All three oscillators are effected by this connection. The effective input range is 0 to +5 V; the result
is dependant upon the panel WAVE control knob setting (a positive CV will add to the setting of the WAVE
control knob).