Moog Music Minimoog Voyager XL - Manual (Page 40)

Page 42
Voyager XL User’s Manual - The Components
Page 43
Voyager XL User’s Manual - The Components
SECTION PARAMETER EFFECTIVE
RANGE
JACK
SUPPLIES
POWER
ENV
RATE -5 to +5V Y
RELEASE +5V ON, 0V OFF N
GATE +5V ON, 0V OFF N
KBD
PITCH -5 to +5V Y
WAVE (Note 1) -5 to +5V Y
FILTER CUTOFF -5 to +5V Y
VCA
VOL 0 to +5V Y
PAN (Note 2) -2.5 to +2.5V Y
LFO
RATE -5 to +5V Y
SYNC +5V ON, 0V OFF N
MOD
MOD1 0 to +5V Y
MOD2 0 to +5V Y
S&H
S&H IN -5 to +5V Y
GATE (Note 3) +5V ON, 0V OFF N
The table below shows the effective ranges of the Voyager XL CV outputs. All non-gate inputs supply
power, allowing you to connect either an Expression Pedal or a control voltage to these jacks.
Note 1: All three oscillators are effected by the WAVE input, and voltage applied to this input
adds to or subtracts from the oscillator WAVE knob settings. Although the WAVE jack will accept
a -5V to +5V input, it only takes a 5V control range to sweep through all the waveforms from
Triangle to Pulse. This means if the oscillator WAVE knob is set at 12 o’clock, the CV input on the
WAVE jack would need to sweep -2.5V to +2.5v to get all the waveforms possible.
Note 2: The voltage range shown covers the complete panning range from Full Left (-2.5V) to full
Right (+2.5V).
Note 3: All GATE inputs will accept a footswitch except for the S&H GATE. A footswitch will have
no effect on the S&H GATE input.
Voyager XL CV Inputs