Moog Music Minimoog Voyager XL - Manual (Page 65)

Page 66
Voyager XL User’s Manual - MASTER Mode
Page 67
Voyager XL User’s Manual - MASTER Mode
MIDI RUN STATUS
The MIDI RUN STATUS (MIDI Running Status) function is used to reduce
the MIDI data sent when a number of MIDI messages with the same
Status Byte are sent. When enabled, the Running Status function eliminates
the Status Byte. Some MIDI devices can handle MIDI Running Status and
some can’t, so you have an option of turning this on (‘YES’) or off (‘NO’).
To change the setting, use the CURSOR to highlight the desired choice
and press ENTER.
MIDI MOD. WHEEL
The MIDI Modulation Wheel function allows you to select the transmission
of 7-bit or 14-bit MIDI Control Change (CC) messages from the Mod
Wheel. Use the -1/+1 buttons to change the setting. In 7-bit mode, only
MIDI CC1 is sent when the Mod Wheel is moved. In 14-bit mode, both
MIDI CC1 (Most Significant Byte (MSB)) and MDI CC33 (Least Significant
Byte (LSB)) are sent when the Mod Wheel is moved.
MIDI PRG. CHANGE
The MIDI PRG CHANGE (MIDI Program Change) function allows you
to enable (ON) or disable (OFF) the reception and transmission of MIDI
program changes. To change the setting, use the CURSOR to highlight the
desired parameter, and then use the -1/+1 buttons to change the setting.
When Receive MIDI Program Change is ON, the Voyager XL will
accept both MIDI Program Change and MIDI Bank Select messages.
When this function is OFF, the Voyager XL will ignore these messages.
In either case, the MIDI LED on the Interface Panel will blink when a
MIDI message is received on the proper channel.
MIDI MERGE FUNC.
When enabled (‘YES’), the MIDI Merge function passes incoming MIDI
Note ON and Note OFF messages from the MIDI In jack to the MIDI
Out jack. When this function is disabled (‘NO’), only MIDI events created
by the instrument appear at the MIDI Out. To change the setting, use the
CURSOR to highlight the desired choice and press ENTER.