Moog Music Minimoog Voyager XL - Manual (Page 5)

Page 6
Voyager XL User’s Manual - The Basics
Page 7
Voyager XL User’s Manual - The Basics
For those of you who can’t wait to play your new Voyager XL synthesizer (completely understandable!), The
following should get you set up and running quickly.
We encourage you to read the entire manual at some point to learn more about the
instrument and gain a better understanding of what you can do with the Voyager XL.
Check the contents in the shipping carton
The Voyager is shipped with the following items:
1. The Voyager XL Synthesizer
2. Patch Cable Kit
3. Power cord
4. This User’s Manual
5. Warranty registration card
What you will need
In addition to the Voyager and provided accessories, you will need:
1. A stand or table sufficient to support the Voyager XL
2. A 1⁄4” instrument cable (for mono) or two 1⁄4” instrument cables (for stereo) and an
amplifier, or a pair of headphones
3. A properly wired AC outlet.
4. A few 1⁄4” patch cords for trying various connections
Set up
Make sure you have an adequate place to set it up. You will need a sturdy keyboard stand or flat surface
that will provide the proper support and will not easily topple. Use caution when lifting the Voyager XL out
of the carton, and be sure to save the carton and all packing material in case you need to ship the Voyager
XL for any reason.
Connect to Power and Amplifier
Make the connections as shown below. Connect the Voyager XL’s power receptacle (on the back panel) to
a wall outlet using the supplied AC power cord.
The Voyager XL universal power supply will operate with a
power source from 90 to 250 Volts AC, 50/60Hz. Do not switch on the power yet. Set the Master Volume
control to minimum before making the connection to an amplifier or headphones.
Setup and Connections