Moog Music Minimoog Voyager XL - Manual (Page 39)

Page 40
Voyager XL User’s Manual - The Components
Page 41
Voyager XL User’s Manual - The Components
LFO
This group of inputs allow you to connect an external signal to control the Voyager’s LFO Rate and Sync
parameters.
RATE: This input affects the LFO Rate. The LFO RATE jack accepts an expression pedal or a CV.
A positive CV adds to the position of the LFO RATE control, while a negative voltage
subtracts from the position of the LFO RATE control.
SYNC: This input affects the synchronization of the Voyager’s LFO. The LFO SYNC jack accepts
a footswitch or a +5V Gate input. Closing the footswitch or applying a gate retriggers the
LFO waveform.
MOD
This group of inputs allows you apply external modulation sources (MOD 2) and modulation control
(MOD 1) to the Mod Busses.
MOD 1: The MOD 1 jack accepts an expression pedal or control voltage from 0 to 5 Volts. This input
is used as the performance control for the PEDAL/ON Mod Bus. With nothing plugged into this jack,
the voltage here is 5V (the ‘ON’ state). With an input applied, when the voltage is at 0, no modulation
is sent to the PEDAL/ON Modulation Destination. When the Voltage at the MOD1 is at 5 Volts, the
Modulation is sent to the destination at the level set by the PEDAL/ON AMOUNT control.
MOD 2: The MOD 2 jack allows you to apply an external modulation source into the modulation
busses. The input accepts an expression pedal or a control voltage of 0 to +5V. With nothing plugged
into this jack, the voltage here is 5 V (the ‘ON’ state). When the SOURCE panel control of either
Modulation Bus is set to ‘ON/MOD2’, the voltage applied to this jack becomes the modulation source.
S & H IN
This group of inputs allow you to connect external signals to control the Voyager XL Sample and Hold
Circuit.
S&H IN : This is the input to the Voyager’s Sample and Hold circuit. This jack accepts an Expression
Pedal or a control voltage from -5 to +5V.
GATE: This input accepts a +5V gate input only.