Moog Music Minimoog Voyager XL - Manual (Page 45)

Page 46
Voyager XL User’s Manual - PANEL Mode
Page 47
Voyager XL User’s Manual - PANEL Mode
QUICK MODE:
The QUICK MODE function is used to select whether preset changes take
effect immediately or if activation must include pressing the ENTER but-
ton. This extra selection step is intended for a live performance situation,
where you may want to dial up a new preset while continuing to play the
current preset. With this function enabled (‘YES’), the newly selected pre-
set only becomes active when you press the ENTER button. To change
the Quick Mode, use the CURSOR to highlight the desired choice and
press ENTER.
PARAMETER DISPLAY:
PARAMETER DISPLAY is used to monitor changes to the values of a
preset’s parameters. There are three choices for this feature as shown.
Choose ‘YES’, and a change in the position of a knob or switch on the
front panel causes the display to show the preset’s stored value and the
new value simultaneously. The last parameter changed will be displayed.
Choose ‘3 sec.’, and the current and stored values are displayed for ap-
proximately 3 seconds before the display returns to the preset name and
number. Choose ‘NO’ and this function is off. To make a change in the
Parameter Display menu, use the CURSOR to highlight the desired choice
and press ENTER.
In PANEL, EDIT or MASTER mode, when you reach the bottom of the menu pages, the next “-1”
button press will wrap back to the top item on the first menu page.
To select a Panel Mode menu function, use the -1/+1 buttons to highlight the desired function and then
press ENTER. A description of the Panel Mode functions follows.
MASTER VOLUME
MASTER VOLUME is used to determine whether the stored Master Vol-
ume value is loaded when a new preset becomes active. If this is off, then
this value is determined by the current position of the MASTER VOLUME
control. To make a change in the Master Volume menu, use the CURSOR
to highlight the desired choice and press ENTER.
The Voyager XL Operating System has been improved to eliminate the step-
ping that can occur when multiple pots are tweaked, but it requires that the
PARAMETER DISPLAY function be set to ‘NO’ to ensure smooth operation.