Moog Music Minimoog Voyager XL - Manual (Page 55)

Page 56
Voyager XL User’s Manual - EDIT Mode
Page 57
Voyager XL User’s Manual - EDIT Mode
5.1 T.S. DESTINATION (Touch Surface Destination):
The Voyager XL Touch Surface produces four controls signals labeled X,Y,
A, and Gate. The X and Y control signals are generated by touching the
touch surface and reflect the left-right position and up-down position,
respectively. The A control signal is generated by calculating the area of
contact with the Touch Surface. The larger the area covered, the greater
the control signal. The Gate control signal is produced when you make
contact with the Touch Surface. Each of the four Touch Surface control
parameters has its own dedicated menu. Use the -1/+1 buttons to select
the desired TS control parameter and then press ENTER.
A new display will appear, similar to the one shown at left for the TSX
control. The TSX, TSY and TSA menus are identical and have the same
assignable options (the TS Gate menu is different, and is covered separately
later in this section). The TSX, TSY and TSA menus allow you to select the
touch surface destination (DEST.), the MIDI Control Number (MIDI CTRL
NO.), the control polarity (DIRECTION), the Amount, and the LFO Sample
& Hold (LFO S&H). The assignable options for each are listed below. To
return to the Touch Surface menu, press ENTER.
Destination (DEST.): There are 32 destinations for the Touch Surface outputs X, Y and A. Note
that the X, Y and A outputs are generated only when you make contact with the Touch Surface.
- LFO Rate
- Glide Rate
- Mod Wheel Mod Bus amount (MOD WHL AMT)
- Pedal/ON Mod Bus amount (PEDAL AMT)
- Oscillator 1 octave (OSC 1 OCT)
- Oscillator 1 waveform (OSC 1 WAVE)
- Oscillator 2 frequency (OSC 2 FREQ)
- Oscillator 2 octave (OSC 2 OCT)
- Oscillator 2 waveform (OSC 2 WAVE)
- Oscillator 3 frequency (OSC 3 FREQ)
- Oscillator 3 octave (OSC 3 OCT)
- Oscillator 3 waveform (OSC 3 WAVE)
- External Audio Input level (EXT. AUDIO)
- Oscillator 1 level (OSC 1 LEV)
- Oscillator 2 level (OSC 2 LEV)
- Oscillator 3 level (OSC 3 LEV) - Noise level (NOISE LEV)
- Filter cutoff (FIL CUTOFF)
- Filter spacing (FIL SPACING)
- Filter resonance (FILTER RES)
- Filter keyboard control (FIL KB CTRL)
- Filter attack (FIL ATTACK)
- Filter decay (FIL DECAY)
- Filter sustain (FIL SUSTAIN)
- Filter release (FIL RELEASE)
- Filter envelope amount (FIL ENV AMT)
- Volume attack (VOL ATTACK)
- Volume decay (VOL DECAY)
- Volume sustain (VOL SUSTAIN)
- Volume release (VOL RELEASE)
- Master Volume (MASTER VOL)
- Key Pitch