Moog Music Minimoog Voyager XL - Manual (Page 25)

Page 26
Voyager XL User’s Manual - The Components
Page 27
Voyager XL User’s Manual - The Components
E. The Output Section
The Voyager XL has two audio outputs. There is a Voltage Controlled Amplifier (VCA) for each output,
which allows for stereo functions such as panning or the dual lowpass filtering. The main control for the
volume is the Master Volume control. The Volume Envelope modulates the output VCAs.
Output Section controls:
Master Volume:
The MASTER VOLUME knob is the main volume control. Full-clockwise is maximum
output, full-counterclockwise silences the Voyager XL.
Headphone Volume:
This HEADPHONE VOLUME knob controls the volume that appears on the
HEADPHONE OUTPUT jack. Full-clockwise is maximum output, full-counterclockwise
silences the Voyager XL.
Headphone Output:
The HEADPHONE OUTPUT connection is a 1⁄4” TRS jack that outputs the audio signal
to a pair of stereo headphones.
VCA Inputs on the Patch Panel:
VOLUME -
The VOLUME jack allows you to connect an external CV or expression pedal to control the output
volume. Both VCA’s are effected by this connection. The effective input range is 0 to +5 V, where
0V = Volume OFF, and +5V = Full Volume.
PAN -
The PAN jack allows you to connect an external CV or expression pedal to control panning between
the right and left outputs. A CV of 5 Volts will control the full panning range, where:
-2.5V = Fully Left
+2.5V = Fully Right
If an expression pedal is plugged into the PAN jack, the pedal will reach its full positive effect over just half of
its useful travel, since it gets +5V from the PAN jack. Note also that you will not be able to pan left with the
pedal without additional offset programming because the Expression Pedal voltage does not go below 0V.