GE Industrial Solutions ASTAT XT User Manual
Page 64
64
• Application diagrams
8.4
Control Supply and Control Input from Separate Sources
Notes:
•
Use this diagram when Control Supply
and Control Input voltages are not
from the same source.
•
Connect terminal 21 as per section
page 62.
•
Supply must be protected for short
circuit and over load. 6A fuse is
recommended.
•
It is recommended to use a separate
fuse for the auxiliary circuits.
8.5
Soft Start, Soft Stop and Stop, Control Supply and Control Input from the Same Source
Notes:
•
Switch A can be used as an immediate
stop.
•
Switch B is used as a soft stop
command to the ASTAT-XT.
•
Switch C is used as a momentary or
maintained start command to the
ASTAT-XT.
8.6
Soft Start, Soft Stop and Stop, Control Supply and Control Input from Separate Sources
See notes to section