Asus ESC1000 G2 - Manual (Page 120)

4-38 Chapter 4: BIOS setup
Main Ai Tweaker Advanced Monitor Boot Tool
Exit
(1) IDE Mode. (2) AHCI Mode. (3)
RAID Mode.
Back Advanced\ SATA Configuration >
UEFI BIOS Utility - Advanced Mode
SATA Configuration
SATA Mode IDE Mode
Serial-ATA Controller 0 Enabled
Serial-ATA Controller 1 Enabled
S.M.A.R.T. Status Check Enabled
SATA 6G_1 (Gray) Not Present
SATA 6G_2 (Gray) Not Present
SATA 3G_3 (Blue) Not Present
SATA 3G_4 (Blue) Not Present
SATA 3G_5 (Blue) Not Present
SATA 3G_6 (Blue) Not Present
The following two items appear only when you set the SATA Mode item to [IDE Mode].
Serial-ATA Controller 0 [Enabled]
Allows you to enabled/disabled the Serial-ATA Controller 0.
Configuration options: [Disabled] [Enabled] [Compatible]
Serial-ATA Controller 1 [Enabled]
Allows you to enabled/disabled the Serial-ATA Controller 1.
Configuration options: [Disabled] [Enabled]
SATA3G_5 (Blue) Hot Plug [Disabled]
This item appears only when you set the previous item to [AHCI Mode] and [RAID mode]. It
allows users to enable/disable SATA Hot Plug Support.
Configuration options: [Disabled] [Enabled].
SATA3G_6 (Blue) Hot Plug [Disabled]
This item appear only when you set the previous item to [AHCI Mode]. It’s allow user to
enabled/disabled SATA Hot Plug Support.
Configuration options: [Disabled] [Enabled].