Asus ESC1000 G2 - Manual (Page 34)

Chapter 2: Hardware setup 2-14
2.6 5.25-inch drives
Installing a 5.25-inch drive
1. Unscrew and remove the metal cover
of the bay where you want to install the
5.25-inch drive, and take off the plastic
cover on the front bezel at the same
position.
2. Insert the drive into the bay and slide
the bay lock to the right until it clicks in
place.
Ensure to unplug the power cable before installing or removing any system components.
Failure to do so may cause damage to the motherboard and other system components!
The system comes with three 5.25-inch drive
bays located on the upper front part of the
chassis. An optical drive that comes standard/
optional with the system package occupies
the uppermost bay (labeled 1). The lower bays
(labeled 2 and 3) are available for additional
5.25-inch optical, zip, or floppy disk drives.
You must remove the front panel
assembly before installing a 5.25-inch
drive.
3. Connect the SATA cable to the SATA
connector on the back of the drive.
4. Connect a power plug from the power
supply to the power connector on the
back of the drive.
2
4
3
3
2
1