Asus ESC1000 G2 - Manual (Page 135)

ASUS ESC1000 G2 4-53
4.8.4 ASUS Drive Xpert
This item allows you to configure RAID setup through SATA ports.
Main Ai Tweaker Advanced Monitor Boot Tool
Exit
Drive Xpert Mode
Back Tool\ ASUS Drive Xpert >
UEFI BIOS Utility - Advanced Mode
Drive Xpert Setup Utility
Drive Xpert Mode Normal Mode
Drive Xpert Device(s) List :
> SATA6G_E1 (Navy Blue)
> SATA6G_E2 (Navy Blue)
Drive Xpert Mode
This item allows you to choose the Drive Xpert modes.
[Normal Mode] Allows you to use the SATA6G_E1 and SATA6G_E2 connectors as normal
SATA connectors.
[Super Speed] Allows you to use the Super Speed function that combines two hard drives
as on single drive partition.
[EZ Backup] Allows you to use the EZ Backup function that copies and maintains an
identical image of data from the SATA6G_E1 drive to the SATA6G_E2
drive.
[Normal Mode]
When using only one hard disk in Normal Mode, connect the hard disk to the
SATA6G_E1 connector on the motherboard.
[Super Speed] [EZ Backup]
Please plug two EMPTY hard drives to the SATA6G_E1 and SATA6G_E2 connectors
before using this function, or else all data stored in the two hard drives will be
destroyed! Mode change might damage the operating system if the operating system
is already installed on one of the hard drives.
Drive Xpert Device(s) List:
SATA6G _E1/ E2 (Navy Blue)
While entering setup, BIOS auto detects the presence of SATA devices. Press <Enter>
to display the information of the hard disks which are connected to the SATA6G_E1
and SATA6G_E2 connectors on the motherboard.
• Before using the Drive Xpert function, please make sure that you have connected
the SATA signal cables and installed SATA hard disk drives to the SATA6G_E1 and
SATA6G_E2 connectors.
• You can only make one Drive Xpert change at a time before you save BIOS settings and
restart the computer.