4 removing and reinstalling the backplane, Removing and reinstalling the backplane -18 – Asus ESC1000 G2 User Manual
Page 38
Advertising
Chapter 2: Hardware setup
2-18
2.7.4
Removing and reinstalling the backplane
DO NOT remove the backplane unless necessary!
1.
Remove all hot-swap HDD trays from the
chassis.
2.
Disconnect all cables from the SATA
backplane.
3.
Loosen the four screws on the
backplane.
6.
Push the tray lever until it clicks, and
secures the drive tray in place. The drive
tray is correctly placed when its front
edge aligns with the bay edge.
7.
Repeat steps 1 to 6 if you wish to install
a second SATA drive.
4.
Firmly hold the backplane, lift it up and
remove it from the module.
5.
Follow the previous instructions in
reverse to reinstall the backplane.
Advertising