Chapter 4 - configuration management, 2 link aggregation – Asus GigaX1024iPlus User Manual
Page 30
21
Chapter 4 - Configuration Management
ASUS GigaX 1024i+
•
Priority: The port priority in the switch. Low numeric value indicates a
high priority. The port with lower priority is more likely to be blocked by
STP if a network loop is detected. The valid value is from 0 to 240.
•
Path Cost: The valid value is from 1 to 200000000 or Auto. The path cost
of the user configuration is displayed in the AdminCost, and the operation
path cost is displayed in the OperCost. The higher cost is more likely to be
blocked by STP if a network loop is detected.
•
Edge Port: All ports are set to be edge ports by default. Edge port
becomes STP port when BPDU is received. Also, it takes a very short time
for an edge port to be in forwarding state.
•
Point to Point: Auto/Yes/No: A full duplex link is considered as a point
to point link. Otherwise, it is a shared link. Point to point link may have less
convergence time. Auto is recommended in most cases.
Click <
OK> to save any changes made to the settings. Click <Reload> to
refresh the settings.
4.3.2 Link Aggregation
This page configures the link
aggregation group (port trunking).
The switch can have 15 link
aggregation groups. It has the
following configuration parameters:
•
Show Trunk: Select Add a new
Trunk to create a new group. Or
select an existing group to display on
the following fields and port icons.
•
Name: The group name.
•
Trunk ID: A number to identify the trunk group besides the group name.
•
LACP: Enable/Disable LCAP on selected trunk. LACP mode is fixed to
be Active.
•
Remove Trunk: Remove the selected trunk.
•
Port Icons: These port icons are listed in a way like the front panel. You
have to click on the icon the select the group members. The port can be
removed from the group by clicking the selected port again.
Click <
OK> to send the settings to the switch via the HTTP server.
Click <
Reload> to refresh the settings. To permanently save the new
configuration, go to the
Save Configuration page, then click <Save>.
Figure 18. Link aggregation