Chapter 4 - configuration management – Asus GigaX1024iPlus User Manual

Page 49

Advertising

Chapter 4 - Configuration Management

ASUS GigaX 1024i+

following fields:
•

DSCP: select the DSCP value.

•

CoS: select the CoS priority.

Click <

OK> to send the settings to the switch via the HTTP server. Click

Reload> to refresh the settings. To permanently save the configuration,

go to the

Save Configuration page, then click <Save>.

4.6.3 Priority Override

The

Priority Override page allows

you to enable or disable the QoS

source MAC priority override and the

destination MAC priority override.
When the source MAC priority

override is enabled, the priority

override based on source MAC can

occur on all ports. A source MAC

priority override occurs when the

source address of a packet results in

an entry hit where the source address has been added to the static MAC

address table and assigned a priority. When this occurs, the priority value

assigned to the static ARL table is used to override the packet’s previously

determined priority. The source MAC priority override has higher priority

than the port’s default priority, IP priority, and VLAN priority override.
When destination MAC priority override is enabled, the priority overrides

based on destination MAC can occur on all ports. A destination MAC

priority override occurs when the destination address of a packet results

in an entry hit where the destination address has been added to the static

MAC address table and assigned a priority. When this occurs, the priority

value assigned to the static ARL table is used to override the packet’s

previously determined priority. The destination MAC priority override has

highest priority over the port’s default priority, IP priority, VLAN priority

override, and source MAC priority override.
If you want to create a static MAC entry and combine the CoS priority,

please go to the