Asus GigaX1024iPlus - Manual (Page 34)

25
Chapter 4 - Configuration Management
ASUS GigaX 1024i+
4.3.7 Dynamic Addresses
This page displays the result of the
dynamic MAC address lookup by
port, VLAN ID, or MAC address. The
dynamic address, which is the MAC
address specified in the lookup,
will expire based on the configured
"aging time". You can enter a valid
number from 15 to 3825 (in seconds)
to configure the expiry time (or aging
time). To save any changes made to
this page, click < OK>. To permanently save the new configuration, go to
the Save Configuration page and click <Save>.
To lookup for MAC addresses, you can check the port, VLAN ID, or MAC
address, and then click on < Query>. The address window will display the
results.
4.3.8 Static Addresses
MAC addresses entered in this page
will not expire, and will remain static
in the address table until you remove
it from the address list.
The
Static Addresses page has the
following parameters:
• MAC Address: Enter the MAC
address
• VLAN ID: Enter the VLAN ID that
the MAC belongs to
• Port Selection: Select the port which the MAC belongs to
• Discard on: You can do packet filtering when the MAC address
appears in the packets as destination address.
To create a new static MAC address
Click on <Add>. The new entry will be displayed on the address window.
Up to 15 entries will be displayed in the first address window, and the other
entries will be displayed in the succeeding pages. Click on First, Previ-
ous, Next, and Last links to navigate through the entries' list.
Figure 23. Dynamic Address
Figure 24. Static Address