Asus GigaX1024iPlus - Manual (Page 33)

24
Chapter 4 - Configuration Management
ASUS GigaX 1024i+
4.3.6 Bandwidth Control
Bandwidth control limits the
transmission rate of selected
frames. The switch supports this
on a per port basis by setting the
configuration in the following fields:
Ingress bandwidth control
• Port: Select the port to configure.
• Control: Disable/enable the
ingress bandwidth control.
• Mode:
• Bcast: Limit the broadcast packets.
• Bcast, Mcast: Limit the broadcast and multicast packets.
• Bcast, Mcast, Dlf: Limit the broadcast packets, multicast
packets and unicast packets because of destination address
lookup failure.
• All: Limit all types of packets.
• Limit Rate: The threshold to limit the total number of the selected
type of packet. For example, if broadcast/multicast is enabled, the
traffic amount of each type will not exceed the limit value. The valid
value is from 70 to 250000(Kbps).
Egress bandwidth control
• Port: Select the port to configure.
• Bandwidth Control: Disable/enable the bandwidth control.
• Limit Rate: Maximum egress transmission rate. The valid value is from
70 to 250000(Kbps).
Click < OK> to send the settings to the switch via the HTTP server. Click
< Reload> to refresh the settings. To permanently save the configuration,
go to the Save Configuration page, then click <Save>.
Figure 22. Bandwidth Control