Xylem handylab pH 12 - Manual (Page 37)

handylab pH 12 Operation
37 ba75368e04 01/2011
Note
The AutoStore function is interrupted if you start other functions, e.g. output
the data storage.
After the function is finished, the AutoStore function is continued. By this,
however, temporal gaps in the recording of the measured values will occur.
Switching off
AutoStore
Switch AutoStore off by:
z setting the save interval (Int 1) to OFF, or
z switching the measuring instrument off and then on again.
6 Confirm with <RUN/ENTER>.
The prompt for the ID number appears on the display.
7 Set the required ID number with <
▲> <▼>.
8 Confirm with <RUN/ENTER>.
The instrument switches to the pH measuring mode and starts
the measuring and saving process.
AutoStore flashes on the display.
e r F
9 9 9 S 1
LoBat
Tref25
nLF
/ K %
RCL
Sal
°
AR
TP
C
M
m
% mg/l
cm
S/
cm
cm 1/
° F
ARng Cal Lin
Tref20
Sal TDS
mbar
O UpH
mV/pH
AutoCal DIN
AutoCal TEC
Time Baud
Day.Month No.
Year
1
Store Auto
Ident