YSI DIQ/S 182-PR System 182 - Manual (Page 118)

PROFIBUS connection System 182
7 - 8 ba76024e01 02/2012
Creating the assignment
of sensor numbers
You want to install an IQ S ENSOR N ET system and, at the same time,
create a specific sequence of sensor number assignments to the
sensors.
Changing the
assignment of sensor
numbers
You want to change the assignment of sensor numbers to sensors in
an already running IQ S
ENSOR N ET system.
Note
When the inactive datasets are deleted, all settings for the sensors are
deleted as well.
Creating the identical
assignment of sensor
numbers in several
systems
You want to install several identical IQ S ENSOR N ET systems and, at
the same time, create the same sequence of sensor number
assignments to the sensors in all systems.
1 Carry out a system start without any sensors (see section
3.10).
2 Connect the sensors to the system in the required order. With
each sensor wait until the system has recognized the sensor.
1 Unplug all sensors from the IQ S ENSOR N ET .
2 Delete all inactive datasets in the list of sensors (see System
operating manual, chapter Deleting inactive datasets of
sensors).
3 Connect the sensors to the system in the required order. For
each sensor, wait until the sensor is recognized by the system
(see System operating manual, chapter Installation).
1 Carry out a system start without any sensors (see System
operating manual, chapter Installation).
2 Connect the sensors to the system in the required order. For
each sensor, wait until the sensor is recognized by the system
(see System operating manual, chapter Installation).
3 Repeat steps 1 and 2 for all other systems and, while doing so,
keep to exactly the same order when connecting the sensors.