Extron Electronics SME 100 User Guide User Manual
Page 127

Sending commands using an RS-232 connection
1.
Use an RS-232 cable to connect a control PC or other RS-232 device to the RS-232
connector located on the rear panel of the SME 100 (see the "
section on page 12).
2.
Open DataViewer (see the "
" section on page 119).
3.
On the Communication Setup window (see figure 96):
3a
3b
3c
Figure 96.
RS-232 Connection Setup Window
a.
Select the
RS-232
tab.
b.
Select values for the following fields.
•
Com Port
(default =
COM1
)
•
Baud Rate
(default =
9600
)
•
Parity Bit
(default =
None
)
•
Data Bit
(default =
8
)
•
Stop Bit
(default =
1
)
•
Handshake
(default =
None
)
NOTE:
COM1
is the default serial port. Communication can be established with
any unused Com Port by selecting the port from the drop-down menu.
c.
Click
OK
. The Communication Setup window closes.
4.
The main DataViewer window appears. Use the
Commands
field to enter SIS commands
and view the responses in the
Responses
field (see
on page 120).
SME 100 • Remote Communication and Control
121