Extron Electronics SME 100 User Guide - Manual (Page 34)

The table on the next page details the resolutions and refresh rates that are available for
EDID emulation and supported by the SME 100.
NOTES:
• There are 24 predefined EDID and 6 custom EDID available.
• Custom EDID is captured from devices attached to the 15-pin HD or DVI
buffered loop connectors (see the "
Rear Panel Features " section on page 12)
and stored in the selected custom EDID slot. Custom 1, 2, and 3 capture EDID
from the 15-pin HD buffered loop connector. Custom 4, 5, and 6 capture EDID
from the DVI buffered loop connector.
• For information on using the web-based user interface to apply or create a
custom input EDID, see the "
Advanced Settings Page " section on page 105.
• For information on using SIS commands to apply or create a custom input
EDID, see "
Input EDID (VGA and DVI) " on page 133 of the " Command and
Response Table for SIS Commands " section.
• If EDID is not captured, the custom EDID resolution and refresh rate defaults to
1024x768 @ 60
Hz.
SME 100 • Front Panel Operation 28