Extron Electronics SME 100 User Guide - Manual (Page 166)

Push and Pull Stream Playback URLs
To verify a running stream, use the templates below to place the stream into the
VLC "Open Network Stream" dialog (see step 6 of "
Playing a Pull Stream
using VLC media player " on page 158). Substitute the SME 100 IP address
for <SME100_IP>. Substitute the destination IP address and port number for
<DESTINATION_IP>:DESTINATION_PORT.
PULL Streaming: URL
RTSP Unicast RTSP://<SME100_IP>/extron
RTSP Multicast RTSP://<SME100_IP>/extron
or
HTTP://<SME100_IP>/web/multicast.sdp
Table 1. Pull Stream URLs
PUSH Streaming:
Unicast (Destination IP must be set to location where stream will be played)
TS/UDP UDP://@:DESTINATION_PORT
TS/RTP RTP://@:DESTINATION_PORT
ES/RTP HTTP://<SME100_IP>/web/output1.sdp
Multicast (Destination IP must be multicast IP address)
TS/UDP UDP://@<DESTINATION_IP>:DESTINATION_PORT
TS/RTP RTP://@<DESTINATION_IP>:DESTINATION_PORT
ES/RTP HTTP://<SME100_IP>/web/output1.sdp
Table 2. Push Stream URLs
NOTES:
• <SME100_IP> is the IP address of the SME100.
• UDP://@:DESTINATION_PORT is typically UDP://@:60000
• Some dependencies may apply with certain versions of VLC.
• For ES/RTP, SAP is available in "Video only" stream mode.
Playing a Push Stream Using Stream Announcement Protocol (SAP)
In order to play a push stream, the VLC player uses SAP to identify streams on a local
network:
1. Open VLC. From the View menu, select Playlist (see figure 107).
Figure 107. VLC Playlist
SME 100 • Reference Information 160