B&K Precision 4052-4055 - Programming Manual - Manual (Page 13)

9
<channel>:={C1, C2}
<parameter>:= {a parameter from the table below. }
Parameters
Value Describe
STATE <state>
Enable or disable
modulation. Note: if you
want to set or read
modulating waveform
parameters modulation
must be enabled.
AM,SRC <src> AM signal source.
AM,MDSP <mod wave shape>
AM modulation wave.
Only AM signal source is
set to INT.
AM,FRQ <am frequency>
AM frequency. Only AM
signal source is set to
INT.
AM,DEPTH <depth>
AM deep. Only AM signal
source is set to INT.
DSBAM,SRC <src> DSBAM signal source
DSBAM,MDSP <mod wave shape>
DSBAM modulation
wave. Only AM signal
source is set to INT.
DSBAM,FRQ <dsbam frequency>
DSBAM frequency. Only
AM signal source is set
to INT.
FM,SRC <src> FM signal source
FM, MDSP <mod wave shape>
FM modulation wave.
Only FM signal source is
set to INT.
FM,FRQ <fm frequency>
FM frequency. Only FM
signal source is set to
INT.
FM,DEVI <fm frequency offset>
FM frequency offset.
Only FM signal source is
set to INT.
PM,SRC, <src> PM signal source
PM,MDSP <mod wave shape>
PM modulation wave.
Only PM signal source is
set to INT.
PM,FRQ <pm frequency>
PM frequency. Only PM
signal source is set to
INT.