B&K Precision 4052-4055 - Programming Manual - Manual (Page 17)

13
1.7. Sweep Wave Command
DESCRIPTION Set or get sweep wave parameters.
COMMAND SYNTAX
<channel>:SWeepWaVe <parameter>
<channel>:={C1, C2}
<parameter>:= {a parameter from the table below. }
Parameters
Value Description
STATE <state> Turn on or off sweep
wave. Note if you want to
set or read sweep wave
parameters, you must
first enable sweep mode.
TIME <time> Value of sweep time
STOP <stop frequency> Value of stop frequency
START <start frequency> Value of start frequency
TRSR <trigger src> Trigger source
TRMD <trigger mode> Value of trigger output. If
TRSR is EXT,
the
parameter is invalid.
SWMD <sweep mode > Sweep way
DIR <direction> Sweep direction
EDGE <edge> Value of edge. Only TRSR
is EXT, the parameter is
valid.
MTRIG <manual trigger> Make the device once
manual
trigger. The
parameter is valid only
when TRSR is set to MAN.
CARR,WVTP <wave type> Value of carrier wave type.
CARR,FRQ <frequency> Value of frequency.
CARR,AMP <amplifier> Value of amplifier.
CARR,OFST <offset> Value of offset.
CARR,SYM <symmetry> Value of symmetry.
CARR,DUTY <duty>
Value of duty cycle.
Only Square can set this
parameter.
CARR,PHSE <phase> Value of phase.
Note: If Carrier wave is Pulse or Noise, enabling sweep is not allowed.