B&K Precision 4052-4055 - Programming Manual User Manual
Page 14
10
PWM,FRQ
<pwm frequency>
PWM frequency. Only
carry wave is PULSE
wave.
PWM,DEVI
<pwm devi>
Duty cycle deviation.
Only carry wave is Pulse
Wave.
PWM,MDSP
<mod wave shape>
PWM modulation wave.
Only carry wave is
PULSE wave.
PWM,SRC
<src>
PWM signal source.
PM,DEVI
<pm phase offset>
PM phase offset. Only
PM signal source is set
to INT.
ASK,SRC
<src>
ASK signal source.
ASK,KFRQ
<ask key frequency>
ASK key frequency. Only
ASK signal source is set
to INT.
FSK,KFRQ
<fsk frequency>
FSK frequency. Only FSK
signal source is set to
INT.
FSK,HFRQ
<fsk hop frequency>
FSK jump frequency
FSK,SRC
<src>
FSK signal source
CARR,WVTP
<wave type>
Value of carrier wave
type.
CARR,FRQ
<frequency>
Value of frequency.
CARR,AMP
<amplifier>
Value of amplifier.
CARR,OFST
<offset>
Value of offset.
CARR,SYM
<symmetry>
Value of symmetry.
CARR,DUTY
<duty>
Value of duty cycle.
Only Square can set this
parameter.
CARR,PHSE
<phase>
Value of phase.
CARR DLY
<delay>
Value of delay.
Note: If Carrier wave is Pulse or Noise you cannot set the modulation waveform.
where:
<state>:={ON,OFF}
<src>:= {INT,EXT}
<mod wave shape>:={SINE,SQUARE,TRIANGLE,
UPRAMP,DNRAMP,NOISE,ARB}
<am frequency>:= {0.002Hz to 20000Hz}