B&K Precision 4052-4055 - Programming Manual - Manual (Page 15)

11
<deep>:= {0% to 120%}
<fm frequency>:= {0.002Hz to 20000Hz}
<fm frequency offset> :={0 to basic wave frequency / 2}
<pm frequency> :={ 0.002Hz to 20000Hz}
<pm phase offset>:= {0° to 360°}
<pwm frequency>:= {0Hz to 4kHz }
<pwm devi>:= {depends on carry wave duty}
<ask key frequency>:= {0.002Hz to 20000Hz}
<fsk frequency>:= {0.002Hz to 50000Hz}
<fsk jump frequency>:= { the same witch basic wave frequency}
<wave type>:={SINE ,SQUARE, RAMP, ARB, PULSE }
<frequency>:= { Default unit is "HZ". Minimum value is 1xe-6 HZ,
maximal value depends on the version.}
<amplifier>:={Default unit is "V". Channel one
minimum value 0.004V, Maximal is 6V. Channel two minimum value
0.004V, Maximal is 20V. }
<offset>:={ Default unit is "V".}
<duty>:={ If wave type is square, range is from 20% to 80%.
If wave type is pulse, range is from 0.1% to 99.9%.}
<symmetry>:={ 0% to 100%}
<delay>:={the maximal value is 2ks}
QUERY SYNTAX
<channel>:MoDulateWaVe?
<channel>:={C1, C2}
RESPONSE FORMAT
<channel>:MoDulateWaVe <parameter>
<parameter>:={return all parameter of the current modulate wave
parameters.}
EXAMPLE 1
set channel one modulation type to AM.
C1:MDWV AM
EXAMPLE 2 Set modulation shape to AM, and set AM modulating wave shape to sine
wave.
C1:MDWV AM, MDSP, SINE
EXAMPLE 3 Reads channel one modulate wave parameters that STATE is ON.
C1:MDWV?
return:
C1:MDWV
STATE,ON,AM,MDSP,SINE,SRC,INT,FRQ,100HZ,DEPTH,100,CARR,WVTP,R