B&K Precision 4052-4055 - Programming Manual - Manual (Page 19)

15
EXAMPLE 4 Reads channel two modulate wave parameters that STATE is OFF.
C2:SWWV?
Return:
C2:SWWV STATE,OFF
1.8. Burst Wave Command
DESCRIPTION Set or get burst wave parameters.
COMMAND SYNTAX
<channel>:BursTWaVe <parameter>
<channel>:={C1, C2}
<parameter>:= {a parameter from the table below.}
Parameters
Value Description
STATE <state> Enable or disable burst wave. Note if
you want to set or read burst wave
parameters you must first enable burst
mode.
PRD <period> When carrier wave is NOISE wave, this
cannot be set. When GATE is selected,
you cannot set this. This can be set
only when trig source is IN (internal).
STPS <start phase> When carrier wave is NOISE or PULSE
wave, you can’t set it.
GATE_NCYC <gate ncycle> When carrier wave is NOISE, you can’t
set it.
TRSR <trigger> When carrier wave is NOISE wave, you
can’t set it. When NCYC was chosen
you can set it.
DLAY <delay> When carrier wave is NOISE wave, you
can’t set it. When NCYC was chosen
you can’t set it.
PLRT <polarity> When GATE was chosen you can set it.
When carrier wave is NOISE, it is the
only parameter.
TRMD <trig mode> When carrier wave is NOISE wave, you
can’t set it. When NCYC was chosen
you can set it. When TRSR is set to
EXT, you can’t set is.