MoTeC M880 - Manual (Page 35)

MoTeC Initial Setup 33
Initial Setup
Before attempting to start the engine the setup parameters must be correct.
Use the MoTeC ECU Manager software to adjust the setup parameters.
Preferably start with a calibration file from a similar engine as this will make
setup faster and easier.
Main Setup
Injectors
Injector Scaling (IJPU)
Injector Current
Injector Battery Compensation
Refer to the ECU Manager help screens for details.
Calculation Methods
Efficiency Calculation Method.
Load Calculation Method.
Refer to the ECU Manager help screens for details.
Load Sites Selection
Selects the range of load points to suit the selected sensors’ operational
range. For example 0 to 100 for a Throttle position sensor.
Refer to the ECU Manager help screens for details.
Number of Cylinders
CYLS 4 Stroke engines : use positive numbers eg. 8 for 8 cyl.
2 Stroke engines : use negative numbers eg. -2 for 2 cyl.
Rotary engines : use -2 for 2 rotor and -3 for 3 rotor.
Trigger Setup
Ref / Sync Mode (REF)