MoTeC M880 - Manual (Page 89)

MoTeC Appendices 87
Appendix K: CAN Bus Wiring - Single Device
When a single device (such as an ECU) is connected to the CAN bus then
the wiring scheme shown below may be used to provide a connection point
for the MoTeC CAN cable.
If the wiring length is less than 2m (7ft) then the terminating resistor is
recommended but not essential.
If other devices are connected to the CAN bus a special wiring scheme is
required, see Appendix J: CAN Wiring - Multiple Device.
1
2
3
4
5 B14 / 13
A13 / 2
B24 / 47
B23 / 48
Black
Red
Green
White
5 Pin Connector M800/M880
0V
CAN-LO
CAN-HI
8V
These wires must be Twisted
Minimum one twist per 50mm (2in)
100R Resistor
* Not essential if the w iring
length is less than 2m (7ft)
5 Pin Connector Type :
Deltron 716-0-0501 (Non Latching)
Neutrik NC5FDL1 (Latching)