Use of the wheel balancing machine, 1 dimension acquisition 18, 1 dimension acquisition – CEMB USA ER100-i (B) User Manual
Page 18: English
18
Use and Maintenance Manual Rev. 12-2012
ENGLISH
Use of the wheel balancing machine
6. Use of the wheel balancing machine
6.1
DIMENSION ACQUISITION
Acquires the wheel dimensions
Enables/disables taper and tread
measurement
Return to main screen
Outside rim eccentricity measurement
(use with the rim only)
NEW WHEEL
Press the button
to acquire the dimensions.
Close the guard to perform the balancing spin.
ATTeNZIoNe
b
efoRe
pRessING
The
buTToN
,
posITIoN
The
Wheel
IN
such
A
WAy
ThAT
ANy
WeIGhTs
AlReAdy
oN
The
RIm
do
NoT
fAll
WIThIN
The
ReAdING
AReA
of
The
INTeRNAl
lAseR
,
ThAT
WAy
excludING
ANy
dImeNsIoN
meAsuRING
INAccuRAcIes
.
WHEEL THE SAME AS PREVIOUS
Close the guard to perform the balancing spin.
The machine in any case checks the wheel dimensions and if they are different from the previous wheel, automatically
measures them again. With this innovative system you can balance a set of 4-5 wheels measuring the dimensions
only once, thus saving a lot of time.
TAPER AND TREAD MEASUREMENT AT THREE POINTS
Press the button
to enable/disable complete taper and tread measurement.
This function uses a special measuring cycle that extends the cycle time by a few seconds.
The setting remains stored even when the wheel balancing machine is turned off.
OUTSIDE RIM ECCENTRICITY MEASUREMENT WITHOUT TYRE
Press the button
OUTSIDE RIM RUNOUT
)
CANCEL DIMENSION SETTING
Press the button
.