CEMB USA ER100-i (B) - Manual (Page 21)

21
Use and Maintenance Manual Rev. 12-2012
ENGLISH
Use of the wheel balancing machine
Displays the information screen
Selects unbalance display in g/oz
Traceability management
Enables/disables wheel in correction position
Splits the unbalance
Displays the second set of buttons
Lift reset with wheel stopped / STOP during spin
6.4 UNBALANCE MEASUREMENT (first set of buttons)
To perform an unbalance measurement spin, close the guard.
After performing a balancing spin, the following are displayed:
1. The unbalance values.
▪ White: wheel locked in correction position / Internal scanning laser positioned on the side.
▪ Light blue: position not reached / Internal scanning laser not positioned.
2. The red weights that indicate the unbalance position.
3. The weight shadows that indicate where the correction weight should be applied: at the top at 12 o’clock or at the
point indicated by the internal laser.
I
f The
“
Wheel IN posITIoN
”
souNd Is eNAbled
,
A souNd WIll be emITTed WheN The coRRecTIoN posITIoN hAs beeN ReAched
.
I
f The uNbAlANce Is less ThAN The ThReshold vAlue seT
, oK
Is dIsplAyed INsTeAd of The uNbAlANce vAlue To INdIcATe ThAT The
Wheel Is WIThIN ToleRANce oN ThAT sIde
.
p
RessING The buTToN you cAN IN ANy cAse vIeW The ResIduAl uNbAlANce
.
T
o Resume WITh The dImeNsIoNs of The Wheel mouNTed
,
opeN ANd close The spINdle
.
when on, it indicates that the lasers are moving
when on, it indicates that the lift pedal is pressed