AAON LC-054 - Manual (Page 26)

26
be removed with the approved cleaning
agent.
Remove Barrier - Soluble salts adhere to the
substrate. For the effective use of this
product, the product must be in contact with
the salts. These salts may be beneath any
soils, grease or dirt; therefore, these barriers
must be removed prior to application of this
product.
Apply CHLOR*RID DTS - Apply directly
onto the substrate. Sufficient product must
be applied uniformly across the substrate to
thoroughly wet out surface, with no areas
missed. This may be accomplished by use of
a pump-up sprayer or conventional spray
gun. The method does not matter, as long as
the entire area to be cleaned is wetted. After
the substrate has been thoroughly wetted,
the salts will be soluble and is now only
necessary to rinse the salts off.
Rinse - It is highly recommended that a hose
be used. A pressure washer on a high
pressure setting will damage the fins. The
water to be used for the rinse is
recommended to be of potable quality,
though a lesser quality of water may be used
if a small amount of CHLOR*RID DTS is
added. Check with CHLOR*RID
International, Inc. for recommendations on
lesser quality rinse water.