CONTREX M-Traverse - Manual (Page 156)

5 - 9
however, you can modify Control Parameter values with
operational data that is unique to your system.
Performance Monitoring Tach
Lead Position
Follower Position
Follower Engineering Units
Product Rate
Position Error
Position Error See Appendix C; MV-49.
PPR Follower See Appendix C; CP-18.
Process Ratio See Appendix C; MV-86.
Product Rate See Appendix C; MV-46.
Profile Ratio See Appendix C; MV-87.
Tach See Appendix C; MV-40.
Traverse Length 1,2,3,4 See Appendix C; CP-02, 04, 06, 08.
Tuning Tuning stabilizes speed error differences between the
setpoint and feedback.
Ring Kits Ring Kits are flange motor mounted sensors that measure
the pulses per revolution (PPR) of the motor shaft.
Resume Enable See Appendix C; CP-32.
RPM Feedback The operating speed of the Follower.
RPM Lead The operating speed of the Lead.
Run The Run discrete input initiates the follower profiling
function. Run can be activated when the M–Traverse is in
F–Stop, however Run cannot be activated when the M–
Traverse is in Jog, Home Seek or Home Return.
Scaling Scaling Control Parameters supply the M–Traverse with
the information that it needs to calculate the ratio of
Follower Lines to Lead Lines, using Engineering Units.
Serial Communications The M–Traverse can interface with a host computer