CONTREX M-Traverse - Manual (Page 51)

3 - 4
Batch Count Key The “Batch Count” Key is a dedicated or shortcut key. You can
directly access the Batch Count parameter (MV-89).
Status Key The “Status” Key is a dedicated or shortcut key. You can
directly access the Alarm Status parameter (MV-51).
Lower LED Display The two-digit Parameter Code is displayed on the Lower LED
Display.
Upper LED Display The Parameter Code's value is displayed on the Upper LED
display. This value can be up to six digits.
Discrete LED Display There are five discrete LED display lights. When a specific
light is “on”, it indicates the following condition:
Run .................. The M-Traverse is in Follower mode and is executing
a profile.
Wait ................. The Wait input (J4 pin 8 ) is active.
Drive Enable .... The Drive Enable output (J1 pin 13) is active.
At-Home .......... The Follower position is within the At-Home band of
the Home position.
Alarm ............... There is an active alarm condition.
To Enter a Parameter Code:
To Enter a Parameter Value:
(For Control Parameters only - Monitor
Variables can not be changed
manually)
To Use the Tach Key:
To Use the Status Key:
To Use the Setpoint Key:
To Use the Batch Count Key:
Press “Code Select”.
Enter a Parameter Code (For a Control Parameter or Monitor Variable).
Press “Enter” (within 15 seconds).
The Parameter Code and its current value are displayed on the LED displays.
Follow the steps to enter a Parameter Code.
Enter a new value (Use the numeric keys) .
Press “Enter” (within 15 seconds).
Press “Tach”.
The scaled Tach - Velocity is displayed (MV-40).
Press “Status”.
The code for the alarm status is displayed (MV-51).
Press “Setpoint”.
The value of the active setpoint is displayed, in engineering units. (CP-01,
CP-03, CP-05, CP-07 or CP-62).
Press “Batch Count” .
The number of complete batch counts is displayed (MV-89).
Table 3-1 Basic Keypad Entry