Multichannel Systems LTP-Director Manual - Manual (Page 35)

LTP-Director
31
5.1.5 Drop Down Menus
The drop down menus in the main menu toolbar belong to the data display. They are one of the
possibilities to change the adjustments of the x- and y-axis. For zooming and scrolling the axes via
mouse, please refer to chapter "General LTP-Director Software Features".
Icon "Axes Default": Resets all axes of all channels to the default. This is 10 to 40 ms for the
x-axis and -2000 to +2000
V for the y-axis.
With the drop down menus you can adjust the axes separately. The x-axis has the unit millisecond,
the y-axis has the unit microvolt. The command "Zoom to fit" for the x-axis and "Zoom to fit"
for the y-axis shows all available data in that window.
The drop down menus in the right part of the main menu toolbar (in this screenshot:
PS Amplitude) are disabled. They belong to the recording display. Please read chapter
"Data Display Measurement Mode".
5.1.6 Control Window Test Mode
Control Window Test Mode: Control window for the experimental protocol in test mode.
The blue window pane on the left side of the main window in Test Mode includes the command
buttons for setting up, controlling, and running a preliminary experiment in test mode. In test
mode, it is possible to test several possible stimulation electrodes and stimulation parameters
before running the actual experiment. During test mode, the raw data is displayed but not
recorded.