Multichannel Systems LTP-Director Manual - Manual (Page 44)

LTP-Director Manual
40
Main Menu Toolbar of Measurement Mode
The main menu toolbar of measurement mode includes the same functions as in Test Mode.
Please read chapter "Data Display Test Mode".
Data Display Measurement Mode
The data of the electrodes, selected in test mode is displayed on the left, and the analyzed
parameter on the right. Data traces belonging to stimulation pathway S1 are shown in red,
data traces belonging to stimulation pathway S2 are shown in black.
The data traces are marked with dots (in red or black). These dots indicate all maxima and
minima, detected inside the region of interest. The region of interest ROI is defined between
two lines. You can adjust the ROI by moving the borders with the mouse. Please read also
chapter "Signal Detection".
It is possible to zoom in on any data or analysis window by double clicking the window.
Hint: To handle the multiple display features, for example, scrolling and zooming, please read
chapter "General LTP-Director Software Features".
On the right part of this display you see the parameter display for the online analysis related to
the four selected electrodes. The drop down menus for changing analysis parameter are enabled
now. Only one parameter is displayed at a time, but all available parameters are analyzed
simultaneously. Hence, it is possible to switch between the different parameters during recording.
The displayed analysis parameter can be selected individually for electrodes marked as somatic
(blue) or dendritic (green), respectively.
In the parameter display, the stimulation pathway is color coded by the color of the line
connecting the data points (red or black). The color of the data points codes different
experimental phases (Please refer to chapter “Data Display Raw Data Mode”).