Multichannel Systems LTP-Director Manual - Manual (Page 74)

LTP-Director Manual
70
3. Click on the right mouse button. Click "Tracking Enabled".
While holding down the left mouse button, move the mouse pointer to the left and right,
or up and down.
- OR –
You can use the keyboard: Press LEFT ARROW or DOWN ARROW to move the selected axis
to the left (down), RIGHT ARROW or UP ARROW to move the selected axis to the right (up).
- OR –
Use the PAGE UP and PAGE DOWN keys for a faster scrolling (larger steps): PAGE DOWN
to move to the left (down), PAGE UP to move to the right (up).
Zooming with the mouse or keyboard
1. Click to enable the zooming.
2. Click the axis you like to zoom.
The mouse pointer becomes a double-headed arrow.
3. While holding down the mouse button, move the mouse up/right to zoom the axis in,
and move the mouse down / left to zoom the axis out.
- OR –
You can use the keyboard: Press LEFT ARROW or DOWN ARROW to zoom the axis out,
RIGHT ARROW or UP ARROW to zoom the axis in.
- OR –
Use the PAGE UP and PAGE DOWN keys for a faster scrolling (larger steps): PAGE DOWN
to zoom out, PAGE UP to zoom in.
Zooming with the zoom box
The zoom box allows the user to outline a region in the display for zooming into.
The box can start at any point, but must be dragged to the lower right to actually cause a zoom.
The zoom action will affect all axes.
1. Click to enable the zoom box.
2. Move the mouse pointer over the display.
The mouse pointer becomes an arrow with a little box.
3. Click any point in the display and move the mouse pointer to the lower right.
The zooming box appears around the outlined region.
4. Release the mouse button for zooming into the selected region.
Zooming with the Zoom In and Zoom Out buttons
1. Click to zoom in all axes or click to zoom out all axes.
2. If you want to zoom only the x- or y-axis, click the respective axis first (the selected axis
will be highlighted with a dotted line) and then click the appropriate zoom button.