Diamond Products SK-B - Manual (Page 22)

$SSOLFDWLRQV
Wire sawing system
6.%
page 22 SK-B_0008_e.mif
9.3 Flush cuts on a wall
Starting the cut
When preparing work the following points must
be taken into consideration:
l Always set up the machine with the cutting
template (see page 29)
l Fit dowels for securing the SK-D in the open
areas of the dowel template
l Use the driving side of the wire
for cutting (Z)
l On the right-hand swivel roll (A) the wire
must be routed inside at the beginning to
ensure best possible positioning of the wire
Finishing cutting
To complete the cutting work push the right-
hand swivel roll (A) inwards so that:
 WKH ZLUH GRHV QRW FXW WKH LQVLGH RI WKH EUDFNHW
 WKH ZLUH LV FDXJKW E\ WKH VZLYHO UROOV DW WKH HQG