Diamond Products SK-B - Manual (Page 56)

0DLQWHQDQFH
Wire sawing system
6.%
page 56 SK-B_0008_e.mif
16.2 Replacing drive bindings
The service life of the drive bindings varies
depending on the employed power unit
(capacity).
When should the bindings be replaced?
The reference dimension is 22 mm from the
top edge to the base of the grooves. (refer to
illustration)
The bindings on the driving rollers and
deflection pulleys must be replaced if the
groove is deeper than 22 mm.
Necessary tools:
 $OOHQ NH\ VL]H       
 2SHQHQGHG ZUHQFK VL]H   
 3ODVWLF KDPPHU
 6HFXULQJ EORFN
 3XQFKHU
Method
 :LWK WKH  PP $OOHQ NH\ GLVPDQWOH WKH GULYH PRWRU 
0 VFUHZV
 'LVPDQWOH WKH FRQWDFW UROOHU ZLWK WKH  PP ULQJ
VSDQQHU  0 VFUHZ
If the bindings are excessively
worn, correct clamping of the
binding in the rim is no longer
guaranteed. The binding can be
thrown off. This can result in
personal injury and damage to
equipment!