Diamond Products SK-B - Manual (Page 50)

:RUNLQJ ZLWK WKH 6.%
Wire sawing system
6.%
page 50 SK-B_0008_e.mif
14.2 Tensioning the wire / Starting
Prior to starting with the machine the wire must
be pulled through by hand.
With the feed the wire must be tensioned prior
to initial use as follows:
 1RW WRR ORRVH 7KH ZLUH ZRXOG RWKHUZLVH QRW VWDUW RU
FRXOG HYHQ VOLS IURP WKH UROOV
 1RW WRR WLJKW 7KH ZLUH ZRXOG RWKHUZLVH EHFRPH
KRRNHG RYHU WKH FRUQHUV RI WKH ZDOO
l Set the feed to approximately 20% of the
maximum value.
l Switch on the power unit
Locate the cause of the stationary wire.
Various causes are possible:
 7KH HGJHV RQ WKH FRUQHUV RI WKH ZDOO DUH WRR VKDUS DQG
PXVW EH URXQGHG PRUH HIIHFWLYHO\
 7KH ZLUH WHQVLRQ LV WRR KLJK DQG PXVW EH UHGXFHG
 7KH ZLUH ZDV QRW SXOOHG WKURXJK E\ KDQG DW WKH
EHJLQQLQJ
 7KH ZLUH FRQWDFW OHQJWK LV WRR ORQJ DQG PXVW EH
UHGXFHG ZLWK GHIOHFWLRQ SXOOH\V
 7KH GULYH PRWRU LV GHIHFWLYH DQG PXVW EH UHSODFHG
Setting up the water supply
see “Water” on page 16.
14.3 Switching on the power unit
Switching on the employed power unit:
Refer to the operating manual of the employed
power unit.
14.4 Working
Working with the employed power unit:
Refer to the operating manual of the employed
power unit.
Cleaning the toothed rack
l During work remove sludge from the
toothed rack with the supplied brush every
two hours to ensure optimum feed.
If the wire cannot not pulled by hand over
the wall, it will not start with the machine!
If the wire does not start immediately when
the machine is switched on, stop the
machine again immediately.
Warning: It is already possible at
this stage, without the wire
subjected to sawing forces, for a
bead to be spun off in the event
of a wire break, which can cause
serious injury!