Diamond Products SK-B - Manual (Page 39)

Wire sawing system
6.% 7KH GLDPRQG ZLUH
SK-B_0008_e.mif page 39
Sintered wire
A sintered wire must be turned at least once
per metre in an anti-clockwise direction when
first used.
In order to ensure regular wear of the wire
beads, frequently change the turn of the wire
by approximately + or -30%, however, never
less than once per metre of wire. The turn
should be changed after each cut.
Galvanic wire
A galvanic wire must be turned anti-clockwise
0.5 - 1.5 times per metre when first used.
In order to ensure regular wear on the wire
beads, frequently change the turn of the wire,
however never less than once and never more
than 1.5 times per metre of wire.
The turn should be changed after each cut.
When flattening starts change the number of
turns as much as possible, e.g. 2 to 4 or even
more.
Sintered wire: Turn when
commencing work
.GPIVJ QH VJG YKTG 6QVCN VWTPU
 PHWUHV WXUQ   WLPHV
 PHWUHV WXUQ   WLPHV
 PHWUHV WXUQ   WLPHV
 PHWUHV WXUQ    WLPHV
Progressed work,
Example: 10 m, sintered
DIWHU VW FXW turn + 3 times
DIWHU QG FXW turn + 3 times
DIWHU UG FXW release 3 times
DIWHU WK FXW turn + 3 times
DIWHU WK FXW release 3 times, etc.
Galvanic wire: Turn when
commencing work
.GPIVJ QH VJG YKTG 6QVCN VWTPU
 PHWUHV   WXUQV
 PHWUHV   WXUQV
 PHWUHV   WXUQV
 PHWUHV    WXUQV
Progressed work,
Example: 10 m, galvanic
DIWHU VW FXW turn + 3 times
DIWHU QG FXW turn + 3 times
DIWHU UG FXW release 3 times
DIWHU WK FXW turn + 3 times
DIWHU WK FXW release 3 times, etc.