Fire Fighting Enterprises FIRERAY 5000 4-Head (Legacy) - Manual (Page 16)

Re-Finding a System - After Adding or Removing Detectors In Use
60 seconds
• Press tick to enable found Detectors
• Any unused Detector channels are switched
off
• Press to re-scan if number is incorrect
• Repeat Alignment (Steps 5 to 9) for any
other Detectors found during the ‘Find’
process
This will be the number of
Detectors found
• Power Down the system
• Connect new Detector(s) or disconnect
unwanted Detector(s)
• Power the system back up, then follow
procedure:
Use to move between icons in the
System Controller Settings, until the ‘Find’
screen is shown
16
0044-034-01 - THESEUS UG - ENGLISH:0044-003-01 User Guide.qxd 23/06/2009 08:39 Page 16