Epetition, Ate and, Verage – Gentec-EO PC-Gentec-EO (for MAESTRO and INTEGRA) User Manual

Page 38: Ower are not accurate in the statistics mode, Raditional, Ommunication, Ettings

Advertising
background image

PC-Gentec-

EO User’s Manual Revision 5.0

37

6.4 Repetition Rate and Average Power are not accurate in the statistics mode

Make sure that you activate the turbo mode on the Integra and that you respect the PC Recommended
Requirement. The Maestro does not have a turbo mode but he can go up to 500Hz on the PC-Gentec-
eo.

6.5 Traditional Communication Settings

The traditional serial communication interface also allows you to operate the MAESTRO from a remote
location. We recommend using the specific serial data acquisition software PCMAESTRO, if no
automated acquisition is involved because it is much easier to use. In the case of automated
measurement controlled by other software, use the following commands to control the MAESTRO. They
are divided into two groups:

The control commands

allow you to change the MAESTRO’s settings without using the

MAESTRO’s touch screen. Remote control commands do not yield any data, they only confirm that
the command has been executed.

The acquisition commands are used to obtain information on the current status of the MAESTRO.
They do not change the MAESTRO’s settings, they return the requested information.

Advertising