Gentec-EO PC-Gentec-EO (for MAESTRO and INTEGRA) - Manual (Page 52)

PC-Gentec- EO User’s Manual Revision 5.0 51
Text Command Parameters Return
PWC Wavelength
Default: Calibration wavelength, (typically 1064 nm)
The following example sets the wavelength to 1550 nm.
Example Response from Monitor
Command: *PWC01550
Get Personal Wavelength
This command returns the wavelength in nm being used on the detector.
Text Command Parameters Return
GWL None Returns the wavelength
value in nm
Example Response from Monitor
Command: *GWL PWC : 1064 \r\n
MEASUREMENT COMMANDS -- CONTROL
Set Anticipation
This command is used to enable or disable the anticipation processing when the device is
reading from a wattmeter. The anticipation is a software-reading acceleration algorithm that
provides faster readings using the detector’s calibration.
Text Command Parameters Return
ANT 1 to turn On, 0 to turn Off
Default: On
The following example sets the anticipation.
Example Response from Monitor
Command: *ANT1