Gentec-EO PC-Gentec-EO (for MAESTRO and INTEGRA) - Manual (Page 53)

PC-Gentec- EO User’s Manual Revision 5.0 52
Get Anticipation Status
This command returns the anticipation status. If the anticipation is not available, it will always be
at “off”.
Text Command Parameters Return
GAN None 1: On
0: Off
Example Response from Monitor
Command: *GAN Anticipation : 0 \r\n
Zero Offset
This command subtracts the current value from all future measurements the moment the
command is issued to set a new zero point.
Text Command Parameters Return
SOU None
Clear Zero Offset
This command undoes the Zero Offset command to set the zero point at zero.
Text Command Parameters Return
COU None
Set diode zero.
This command subtracts the current value for all available scales from all future measurements
the moment the command is issued to set a new zero point for a photodiode only.
Text Command Parameters Return
SDZ None DONE
Set User Multipliers
This command is used to set the value of the multipliers. The default value is 1.
Text Command Parameters Return
MUL 8 characters numeral value